Відео

Thanks for this!

Yes sir. 🫡

Yes

I can't

I can move my ears whenever I want

Ok

Bună seara ce se întâmplă dacă pui firele greșit l a termostat ☺

Thanks! I have one light that stays on…Will check the other bulb! Hopefully it is that simple - bad bulb and bad switch..

Aight imma try this tomorrow youtube taught me how to do an oil change on my 04 honda Accord now I must learn the breaks this video makes it look easy. I hope it is for me aswell. 🙏🏾

I cant

Ez

Yes

I can

Be whole lot easier if you would turn the wheel ❤

I can do both

Who is better 2 tube?

She's a pro!!!... 👌

Loved the dental flosser idea 💡

How does squeezing the contact fix it?

Thank you

I can move my ears I just smile

Thank you. underneath the bumper, the clips have screws that make them expand and clamp... so you can loosen those to keep from breaking any plastic,.

My obdII tells me that my idl problem is caused by the thermostat

I can

Leave the sea life alone.

Same yug3255 😂❤

Yes

Thank you!

Hi. This is what I have, does it indicate a bad relay? Whirlpool WRT111SFDW03. 7 years old. 11.2 cu ft size. Freezer on top. Start relay P/N: WPW10448874, aka W10448874. Capacitor ("cap") P/N: WPW10662129 Test relay connections with capacitor on the relay. Results: when together I can get cap to charge and discharge thru the start relay, just like it does when it's off the relay. With cap off and on, neither of the lower holes have continuity with each other. The hole on lower left has 0.0 ohms resistance thru the bottom blade of the back of the plug. The lower right hole has no continuity with anything but can be used to charge the capacitor for testing. The upper hole has 0.1 ohm resistance to the top blade on the opposite side. Remove relay cover and visually check. I cannot get combination relay apart without breaking it, so I haven't committed to that, yet. Ohm test the fridge compressor pins again. Make sure the Common (top) and lower pins are within 3 ohms. And the two pins at bottom should read about the sum of the Common with the Start and Run pins. See UA-cam video... Results: Top and Lower Right : 4.4 ohm. Top to Lower Left: 6.0 ohm. Two bottom pins: 10.4 ohm. None of the pins are shorted to ground. My problem is it suddenly stopped cooling without noises or warning, but I caught it from hearing loud buzzing noise from compressor and relay area, and compressor was very hot. No smoke or smells though, and wires did not seem to be hot. Do you think it's the combination relay? Thanks!

Thanks

What’s the best tool to use on this outside drain to open??

Excellent 👍👍

Yes

Yess

these need to be regulated to al follow the simplest design, all of them.

I can move my ears now and then

I could it feels like you’re moving your head

I can move both at same time i can also do one ear and the other onces and both at same time

I can do it on comand

I can take I can move my ears

Yes

I could move my ears

I did it before when I was eight years old no need to for me to act like a show off or anything

Cant

Yes I can move ❤

No

Yes I can move my ears

Yes

Thank You

Yes i can and I can move them when ever I want